Hi
I recently upgraded to RH 11.0.4.291 and FM 12.0.4.445.
I have been importing a FrameMaker book into RoboHelp for several years, without any issues. The Framemaker book is a "master" book consisting of 17 books. Some of the books have multiple chapters. For these, I created a folder each sub book and put the chapter files in the folder. Until today, when I imported the FrameMaker book into the RoboHelp project, and I got the FrameMaker TOC structure in RoboHelp:
Book A
Chapter 1
Chapter 2
Chapter 3
Chapter 4
Book B
Chapter 1
Chapter 2
Chapter 3
Chapter 4
Book C
Chapter 1
Chapter 2
Chapter 3
Chapter 4
When I imported the FrameMaker files into RoboHelp today, I got this:
Book A
Chapter 1
Chapter 2
Chapter 3
Chapter 4
Book B
Chapter 1 from Book A
Chapter 2
Chapter 3
Chapter 4
Book C
Chapter 1 from Book A
Chapter 2
Chapter 3
Chapter 4
Book D
Chapter 1 from Book A
Chapter 2
Chapter 3
Chapter 4
Book E
Chapter 1 from Book A
Chapter 2
Chapter 3
Chapter 4
Chapter 1 from Book A appears in the TOC for every book. Also the content in the project is Chapter 1 from Book A (it's not just the TOC that is wrong, the htm files for Book A/Chapter 1 are also repeated in Chapter 1 of Book B, and so on. Only Chapter 1 was erroneously used in every book. All of the other chapters were correct.
I tried removing folders and chapters from the FM book file and it did not help. The resulting RH just did the same thing, but this time it copied Chapter 1 from what is now the first folder in the FM book.
Has anyone seen this? I am up against a deadline (of course). Any suggestions would be much appreciated.