Greetings, thank you all in advance for any assistance. TCS 3.0, Windows 7, 8GB RAM, enough horsepower. Importing a FrameMaker book into a new help project consistently crashes RoboHelp. I have used this exact setup to import other, longer, more complicated books without issue. I have even imported earlier versions of this book numerous time without problem. A few months ago I needed a new version and it started this crash routine. On a different chapter each time. Sometimes it would crash right away, other times it would nearly complete the book before going down. I was finally able to import the book and have been making updates in parallel with both programs rather than going through this import crash issue again. It is at the point that the new changes make this workflow untenable. The only thing I could think of that makes this book different than the other one was there are a number of tables where I pasted icons in rather than importing them by reference. Since the reference was not practical in this instance, I recreated all of the tables in Illustrator and imported the .ai files by reference. Still crashes every time. I tried going through the temp folder to see if I could find a trace of the problem. The fm files seemed to convert properly, the mif files look fine. There are a lot of small PDF files that represent icons imported by reference that are separate from the other icons. Any hope out there?
↧
RoboHelp crashes when importing Frame book
↧